All positions gone after "import the path"!

[Mclerx]

Hello everyone,
I built a show in the virtual 3D simulator and put everything in position. I start the next time, and I confirm the question: "import the path" (of the program), then all my fixtures will be on 1 line.
My entire setup is then gone. How can I import the path without destroying my entire setup?

[Mclerx]

Nobody here with the same problem?

[colorrush]

Try to not mport the path if your setup is already built, it resets fixture positions. And open your saved show file directly to preserve your layout instead.

[Mclerx]

That is exactly what I am doing at the moment. But if I add some fixtures to the program, it would be nice if I could take them over from the program, without losing all the other positions!