Ich versuche sein 2 stunden simple led pars auf den Boden zu platzieren
die Moving Heads an der decke kein Problem aber wenn ich wie im tortureal led Par scheinwerfen auf den Boden will geht das nicht . aber im Video ist das automatisch auf dem Boden .
was mache ich falsch.
generell finde ich die Positionierung schwer in dasligth 5 habe das Gefühl das es immer davon ausgeht das die Lampen an der Decke sind.
Danke für eure Hilfe
Scheinwerfer auf Boden Platzieren klappt nicht
-
medical1981
- Posts: 6
- Joined: Sat Sep 14, 2024 5:02 pm
- Operating System: Windows
Re: Scheinwerfer auf Boden Platzieren klappt nicht
Hello,
The software itself, and specifically what you see in the 3D Visualiser may not always match exactly depending on how you have set up the physical fixture in the venue.
In the 3D visualiser, yes- all moving head fixtures are automatically placed so that the base of the fixture is flat against the ceiling, meaning that a value of Pan 127, Tilt 127 points the beam directly down at the floor. If you have oriented your fixtures differently to this, then those values will not point to the centre anymore.
The best solution is to:
- Ensure that the fixtures are oriented correctly in the 3D visualiser, as you will have them set up in the venue.
- Set the desired Movement Limitations in the Setup screen, so that the Min/Max Pan and Tilt do not exceed the area that you want the heads to work in.
If you have a video demonstrating the problem as it appears on your side, as well as the .dvc project file- I could probably provide some more specific info for you to set this up. You could attach these as a Google Drive link to this thread (be sure to set the correct Sharing settings if you do!).
Kind regards,
Will
The software itself, and specifically what you see in the 3D Visualiser may not always match exactly depending on how you have set up the physical fixture in the venue.
In the 3D visualiser, yes- all moving head fixtures are automatically placed so that the base of the fixture is flat against the ceiling, meaning that a value of Pan 127, Tilt 127 points the beam directly down at the floor. If you have oriented your fixtures differently to this, then those values will not point to the centre anymore.
The best solution is to:
- Ensure that the fixtures are oriented correctly in the 3D visualiser, as you will have them set up in the venue.
- Set the desired Movement Limitations in the Setup screen, so that the Min/Max Pan and Tilt do not exceed the area that you want the heads to work in.
If you have a video demonstrating the problem as it appears on your side, as well as the .dvc project file- I could probably provide some more specific info for you to set this up. You could attach these as a Google Drive link to this thread (be sure to set the correct Sharing settings if you do!).
Kind regards,
Will