Dashlight 4 MIDI control

[Juhberci]

Hi there,

I'm quite new in light shows, so appologize, if I have dumm questions.

I would like to control my lights (6pieces of sandard 36 led lights) via midi with my lp16. I managed to figure out, how I can assign a certain midi note to start, and stop a scene, but I have the following issue:

As soon, as I want to activate 2 scenes (2 lights to light up to a beat, and 2 lights to strobe), they cancele each other. As long, as there's 1 scene, it works perfectly, but together not. The scenes are triggered on the same MIDI channel (same issue, is I put them on a seperate), and by 2 seperate notes.

Did someone meet the same problem?

Thank you very much

[lilywilhem]

Hi there,

I'm quite new in light shows, so appologize, if I have dumm questions.

I would like to control my lights (6pieces of sandard 36 led lights) via midi with my lp16. I managed to figure out, how I can assign a certain midi note to start, and stop a scene, but I have the following issue:
tiny fishing
As soon, as I want to activate 2 scenes (2 lights to light up to a beat, and 2 lights to strobe), they cancele each other. As long, as there's 1 scene, it works perfectly, but together not. The scenes are triggered on the same MIDI channel (same issue, is I put them on a seperate), and by 2 seperate notes.

Did someone meet the same problem?

Thank you very much

I have the same issue now. Did you find any solution?

[TomHat]

Hi,

I'm going to need to take a look at your show files...
Difficult to say what's going on from here, as it could be a simple "release" setting to change on each of your scenes (so they can play together and don't turn eachother OFF). Or it could be something more complex wich I can only see with your showfiles at hand.

Regards,