Rotation

colmrs · Post by **colmrs** » Tue Dec 01, 2009 5:33 pm

hi me again when i create a circle of say pars how do i rotate them as a group so they are centered on the same spot????

thanks in advance

Andre · Post by **Andre** » Tue Dec 01, 2009 9:08 pm

You can't !!!!!!

Post by **simonB** » Thu Dec 03, 2009 1:10 pm

This is possible with the virtual 3D simulator in full mode. You need to group the pars you wish to rotate around a central point into their own layer(not folder) and then select the "link" checkbox. See the working with layers tutorial under the Virtual 3D simulator heading

http://www.daslight.com/tutorials/

Note that it's not possible to create new layers if working in Limited Mode. You are limited to the Objects and Fixtures layers. The only way of doing this in limited mode is if you drag all the fixtures you do not want to include in the circle into the objects layer.

Andre · Post by **Andre** » Thu Dec 03, 2009 5:28 pm

simonB wrote:This is possible with the virtual 3D simulator in full mode. You need to group the pars you wish to rotate around a central point into their own layer(not folder) and then select the "link" checkbox. See the working with layers tutorial under the Virtual 3D simulator heading

http://www.daslight.com/tutorials/

Note that it's not possible to create new layers if working in Limited Mode. You are limited to the Objects and Fixtures layers. The only way of doing this in limited mode is if you drag all the fixtures you do not want to include in the circle into the objects layer.

Thanks for that always wondered how I could do that, I always had to do it the long way.