Can't play more than one scene

[Toolbox]

Hello everybody

I am preparing a simple light-show for a theater. I have the virtual controller 3 on my laptop in demo mode.

Now I have the problem that I can't play more then one scene at a time. I made two scenes so far. Both have a dimmer-fader on the icon because the idea is to fade from one scene to the other. When I turn on scene 1 and then want to turn on scene 2, scene 1 turns off automaticaly.

What do I do wrong? I made many lightshows with Daslight and never had this problem before.

[Richard CSL]

in DVC3 the release general tab is default, this means only one scene at a time will be active.
un check this in the properties panel in the editor page.

[lxrixta]

Further to Richards reply, there is a button at the top of that section that saves the current settings as the new default, so if you are creating several scenes that all need to run together save the new default setting with general release off, this will save you a few extra clicks each time!

[Dj-Twannie]

Hi,

You have to click by properties (of all yout senes) the release to GROUP.

Then you can click on a difrent sene in every group.

Good luck!!!