Problem after sw update
Posted: Tue Jan 03, 2012 2:24 pm
HI everybody!
Someone may had the same issue and probabily could help me...
I have a DVC2 Gold (SIUDI 5A /293755099). I changed my laptop recently .The new one is running under Win 7 (but a 32 bits version). The module was previously perfectly working with virtual controler 2.
When I changed the PC, I re-installed VC2 but the software was still in demo mode, unable to recognize the interface. So I installed VC3 to test it... same problem... BUT, when I use the Virtual Controller 3 Tool, I can upgrade the interface and control it!
Is it a driver issue? The driver installed is the "Intelligent USB DMX Interface (Stand Alone 2006) version 1.6.0.0
Thx for your help!
Robololo
Someone may had the same issue and probabily could help me...
I have a DVC2 Gold (SIUDI 5A /293755099). I changed my laptop recently .The new one is running under Win 7 (but a 32 bits version). The module was previously perfectly working with virtual controler 2.
When I changed the PC, I re-installed VC2 but the software was still in demo mode, unable to recognize the interface. So I installed VC3 to test it... same problem... BUT, when I use the Virtual Controller 3 Tool, I can upgrade the interface and control it!
Is it a driver issue? The driver installed is the "Intelligent USB DMX Interface (Stand Alone 2006) version 1.6.0.0
Thx for your help!
Robololo