Daslight Forum

Hi

I have tried to open a DVC2 show with version 3 but it crashes annd shows the "Windows has stopped working " screen.

I am using Windows 7 Ultimate (32bit Version).

Also by installing Version 3 with this effect Version 2 already installed. I have noticed when I use version 2 now the interface is now showing at DVC3. I haven't used any of my lights yet so I am hoping all the DMX values are being sent!

regards

Sean

Hi
We are aware of the DVC2 show problems (see thread below this one). We'll look into it throughout this week. The DVC3 installation should not affect DVC2 in any way.