Daslight Forum

I just setup scenes to the Gold interface and for the most part they work fine. I noticed that I can trigger a scene to start, but I can't make it stop unless I create a scene for that fixture that turns it off. Is that the correct way to deal with that? I want the scene to continue till I turn it off. On the PC software I can click on and click off, but not on the interface.

I have some fixtures that have scenes that will turn on and change to other scenes, but when I create a "off" scene, it doesn't even transfer to the interface. It works on the PC software as expected. These fixtures are more complex than the ones mentioned previously. Any guidance would be appreciated.

Check memory usage. In the PC software, use the standalone export tool to see how much memory each scene uses.geometry dash spam