Daslight Forum

Hello all.

My DL5 doesn't receive or send OSC when I connect my TouchOSC. I tried with Resolume and other softwares and runs perfectly. This is hapenning to someone here?

Hello,

Thanks for raising this post! I have tested this myself and OSC seems to be working fine for me, so it would be great if we could first check the following:

- Is OSC input and output enabled within the OSC tab of the Settings window?
- Have you set the correct IP address so that it matches the one your computer is on?
- Have you set the input and output ports correctly so that Daslight input port = TouchOSC output port, and vice versa?
- Have you enabled the 'Broadcast' bool?
- Have you tried re-enabling the LAN access settings for Daslight? You can do this via the steps below:

- Close Daslight 5
- Go to System Settings -> Privacy and Security -> Local Network Access
- Turn off permission for Daslight 5, wait a couple of seconds, turn it back on
- Start up Daslight 5 and now try again with Daslight Remote

Kind regards,
Will