Daslight Forum

Hi,
I want to use my dvc Gold as a stand alone device, where i have one lightshow on button 1 and another lightshow on button 2.
But i don't understand how to load a show onto the "2"-Button.
When i select zone 2 in the (software) stand alone mode in Daslight 5 it just loads the second lightshow on button 1 as well with a different "name". Both lightshows are on button "1" the first one is A01 and the other lightshow is B01.
Is there a manual that explains that?
Where can i load different light shows to the different buttons?
thank you for your help.

Hello,

Appologies for the late response. These 1-10 buttons are programmed to play your scenes in the order you wrote them.
So :
- Button 1 will play the first scene in the zone
- Button 2 will play the second scene in the zone
- Button 3... the third in the zone, and so on till button 10.

Now if you switch to the next zone, your buttons will play respectively the first 10 scenes in this new zone.

Note that each zone can play ONE scene each at any given moment.

Hope this helps.
Regards,

Great. Thanks for the reply TomHat. I've been looking for this for quite a while. geometry dash spam