Daslight Forum

When live adjusting a fixture, it is not visible what the current value is when live adjusting a scene.
If you want to correct a fixture (movinghead) to adjust the position, when I enable live, it sets the position to P:50% T:50%.
Please make it possible before enabling the live-mode, you can already see what value the faders are and when enabling, it keeps its value and you can adjust it accordingly.
It is also necessary to be able to get live midi and OSC feedback. When I use midi with motorized faders or OSC, the values need to be always synced.

Now we are working blind.

I still hope this will be implemented in a future update.

Hello,

Thanks for bringing this again to our attention, I will make a note of this for the developers to look into as I believe it is a good idea to have. I can make no guarantees as to if/when this would be implemented, or if it is actually possible with Daslight 5's current setup- but it will be checked and evaluated nonetheless.

Kind regards,
Will

Is there any information of whether or not it could be possible? As it is now impossible to do live adjustments with moving heads as it will reset the pan and tilt positions, instead of showing and starting at the current values.

Hello,

Unfortunately there is no update on this suggested feature at the moment. It is still on the list of future ideas, however I can not indicate if or when it would be implemented.

Kind regards,
Will