Daslight Forum

I can't save the setup if I check reverse Pan or Tilt on a moving head. Each time I open the software they are unchecked.
THANKS

Hello,

The reverse state of your moving head is false by default when you patch a new one.
The state of each moving head is however saved in your project so that when you reopen it, the reverse state should be properly loaded.

If it is not the case, please send your project to [email protected]

Thank you for your reply. I had opened a Daslight 4 project with Daslight 5 and it's true that you can't save the changes in the setup. On the other hand, if I patch a new moving head I can save the changes. Too bad for those who have big projects that go from D4 to D5.