Since 5.0.1 the Dimming-Curve on Superscenes did not work anymore

[mheidler]

Since the las Update I can not use the Dimmingcurve in a Superscene.
If I dont set any points there, tight comes out. If I set one ore more points, there is no Output on the Dimming-Channel.
If I remove the points again, dimming-channel goes back to 100%.

Regards,
Michael

[attachment=0]Bildschirmfoto 2023-04-13 um 16.53.15.png[/attachment]

[klauslein]

Yes. I have the same problem. But only since the last update...

[juls]

Hello
I cannot reproduce.
Can you try to install again.
Regards

[mheidler]

I have reinstalled the software and now it works.

Thank you,
Michael