Page 1 of 1
Startup DVC2 takes a long time
Posted: Thu Jun 23, 2011 1:26 pm
by DJ-Rene
When i start Daslight VC 2 (Version 05/05/2011) it takes about 3 Minutes to load my show. When i startet Daslight with the devault show it starts immediately.
Why does the startup with a programmed show take so long?
Posted: Fri Jun 24, 2011 6:50 am
by simonB
e-mail me your show and I'll test
Posted: Sat Jun 25, 2011 1:16 pm
by DJ-Rene
I#ve send you my show, thanks for your support!
Posted: Mon Jun 27, 2011 7:34 am
by DJ-Rene
simonB wrote:e-mail me your show and I'll test
Hi Simon, did you have any Infos for me about the problem with my show?
Posted: Tue Jun 28, 2011 9:38 am
by simonB
I timed your show and it took 23 seconds to load. I have sent your show over to the developers to see if this is normal or not
Posted: Sat Jul 09, 2011 8:42 am
by DJ-Rene
simonB wrote:I timed your show and it took 23 seconds to load. I have sent your show over to the developers to see if this is normal or not
Any Updates?
Posted: Mon Jul 11, 2011 1:52 pm
by simonB
Hi, we took a look at your show.
It is normal to have a wait as you have used a lot of scenes and some scenes contain over 800 steps. There are a total of 11139 steps in your show.
3 minutes seems a long time though, maybe you should upgrade your computer. I loaded your show in 23 seconds and I tested on a standard middle range 2 year old dell computer which took 18 seconds.
Posted: Wed Jul 20, 2011 5:05 am
by DJ-Rene
Thanks Simon, I'm using Daslight on a Netbook. It's not powerful PC, but it's only for lightcontrol and when Daslight up it works very fine.