Daslight Forum

Two short questions for the DVC GZM:

1. Is it possible to trigger standalone-scenes by external DMX-Controler?

2. Is the Ethernet-Port only for ArtNet or can I connect the interface to DasLight 5 by ethernet instead of USB? If yes, witch one would you prefer?

Thank you and regards,
Michael

Hey,

First Question:
Yes this is possible.
Open the Hardware Manager and change a DMX port on the GZM from OUTPUT to INPUT. Then in Daslight go to Mappings > Map DMX. You can use this like the MIDI Mapping options.

Second Question:
I think the Ethernet-Port is only used for ArtNet. If you wanted to control the GZM with this port you had to connect them via IP and configure this in the settings. This would be too much for a normal customer. But you can correct me if I‘m wrong.

Regards,
Matrix