Daslight Forum

I've noticed an issue on fixtures with multiple dimming channels where only one of the dimmers shows up in the Dimmer tab or the Other tab, only the Faders tab. Since we can't apply effects to the faders themselves, it leaves me with plenty of fixtures that I can't do any dimming effects with.

I had the same issue with two of my fixtures. I finally solved this with seperating the fixture into two single libraries wich I just setup after the other in the layout. So I devided the fixture into part one and two. But after all I wished the ScanLibrary-Editor would be updated to specicify correspondeding channels.

Hello.
With which fixture do you have this problem ?
Regards

For me it is ETEC LED Mini Eye 7 and FOS Smart Beam 150W

juls wrote:Hello.
With which fixture do you have this problem ?
Regards

I've had this issue with Litelee's Big Eye and a couple of Chinese movers.