Daslight Forum

Hi,

I´ve some problems when I close the Daslight4 Software.

Setup: 4 Moving Heads, 5 Pars, 2 Flood Panels

If I close the software, the moving heads are still moving, 2 of the 5 LED pars are still on and make a rainbow color change, 1 of the 2 flood panels is still on in white mode.

The problem also exists if I disconnect the usb cable.

Therefore my intention was that the usb device is playing in standalone mode.
I´ve completely reseted the USB device in the hardware manager.

The problem still exists

Someone who have the same problem and give me some hints?


Thanks,
kraimor

Hi kraimor,

Try writing a empty show to the Stand Alone memory. This can be done in the Hardware Manager.

Hi kraimor,

first I would check how your light devices are configured. Most of the devices nowadays do have the ability to define how they should act when the DMX signal is lost. Typical is that you can choose between blackout, last dmx status and autoshow.

Regards, Torsten

Hi,
Do you have the Terminator at the end? If not, the lights by default search for signal...

Terminator is installed.

The problem was a saved show on the hardware.

Thanks Benno