Daslight Forum

POLL Auto change from HTP/LTP to AUTO in live mode

SEAMUS wrote:POLL Auto change from HTP/LTP to AUTO in live mode

What would trigger the change ?

Trigger would be if the channel was used in any scene then playing that scene would reset the LTP/HTP to Auto.

SEAMUS wrote:Trigger would be if the channel was used in any scene then playing that scene would reset the LTP/HTP to Auto.

That is what I thought you meant. Have voted YES.

When I think about it if we had a program button that would add what channels were adjusted on to the scene and then return the channels to auto that would be simpler to work with.

or even if we could bind a key for each htp ltp and auto so we can change it at the press of a button

I think it should be kept as simple as possible. i.e. If a scene uses channels that have been overridden by HTP/LTP/IN etc. then if the scene is started it should reset them or at least leave the sliders where they are so you can re-grab them or set to HTP/LTP/IN etc. and it has remembered the slider postion. That would be most useful.

I do not have any problems in resetting the fixtures from HTP/LTP/IN etc back to auto I use the little hand icons above the fixture selection. Each hand does it's own thing.