Daslight Forum

Hi there! I'm newbie in daslight and i have a question. On our stage we have ETC Congo + etc DMX/RDM Four-Port Gateway. In Dl4 i created virtual device with IP and Mask for our ArtNet, but then nothing to do. What i can to do, that it's work?

Hi viKdc, to use Daslight 4 with ArtNet you need a DVC3/4 GZM controller along with a ArtNet node.

can the daslight gzm connect into the artnet node, so all the channels are coming out of the node into the fixtures ?
or is it a seperate connection ? 3 universes out of the gzm and 3 universes out of the node

( im asking because i have a 8 universe node, and i would like to run all 6 universes from the node into the lights )

thanks

Hi matthieu, it's not possible to have all 6 universes coming out of the ArtNet Node. As you say it's 3 universes out of the GZM and then 3 universes out of the ArtNet node. Kind regards