Daslight Forum

Hi guys,

I have set up a system on DVC3 so it can control two moving heads and two scanners. However I want them to have separate controls.

My issue is when I start a show for the moving heads, then press the button for the scanners, the moving bead scene stops, is there anyway I can use both sets of fixtures but with seperate control?

Hi FURY,

Sounds like you need to separate your scanners & moving heads into two groups. Also make sure you set the scene release you 'group' in the properties.

Check the DVC3 user manual for more info.
http://manuals.daslight.com/en/540-601- ... Sb9Sg1.htm