Daslight Forum

Hi,
this is my 2nd try to give a chance to dvc3 comming from Licon1X.

Simple 1st configuration making a generic PAR64 chase with three PAR64.
Red, green, blue

Named Scene 1 in group 1 Chaser 1.
Release off

Start scene 1
255-0-0
0-255-0
0-0-255
255-0-0
aso
No Problem at all

Next step
New Group and scene named Backlight blue
Release off
DMX 57 on Channel 3
Start scene 2
0-0-57
No Problem at all

Configured in live all three channels to HTP
Run both scences

255-0-57
0-255-57
0-0-57 <<<-- Problem with HTP on

Additional Information:
Set fader channel 3 to dmx255 in general it isn't possible to revert to dmx0 in general.
Switch to PAR64 section and set fader to DMX0 will set the DMX to 57 again.
Always HTP is on. Set LTP in general no problem, but the chase from scene 1 is not working prblably on channel 3.

Tested with Beta Oct. 6 2015
and Release Aug 18 2015

Any suggestions?

No one interested in solving the problem or say anything regarding to it?

Am i stupid?
No one has the same problem?

Hi, can you send me your showfile so I can take a look for you?

Can you pm your Mail-Adress?

Okay,

Version 02/12 works now but not for 100%

HTP works if i manually set a fader to a different value on general tab.

But if i start another scence where the dimmer is present only the last started scene did work.

All channels set to htp

eg Channel 1-3 Scene Chaser
Channel 1 Scebe backgroundlight

1st -- Set Scence Chaser to on all off 3 Channels work
2nd -- set scene Backgroundloght
the chaser work only on channel 2-3

1st -- set scene background to on
2nd -- set scene chaser to on

Supprise. In my scene channel 1 is set via dimmerfader to 20% and set to htp.

The chaser sets the value form 0-20% but the scence should work 20-100%.

Please help.

@Benno your email adress is still required.

Hi Chris, I sent my email address to you last week using the address registered for this forum. I have resent just now so please check your spam folder as it may have gone in there. Kind regards.

Hi Christian

HTP and LTP determine the channel priority between the fader and the scene, not between scenes. Unfortunately it's not possible to combine scenes in this way in Daslight (we may consider integrating it in future). The Sunlite Suite 2 software from our Nicolaudie brand has the possibility to do this however.

HI,

thanks for reply.
Bought a DVC 3 GZM a few days ago. So Sunlight Suite 2 is no option at all. Ambient light is now working after last fix (HTP). Have to set every fader manually in global tab.

But I am sad that this does not work that way.
Hope that could be a function in further versions.