Daslight Forum

Hi there,

I want to use an AKAI Apc mini to control DVC3 Software but apparently DVC3 receives no signal at all. I already tried with my APC40 as I thought it should send similar notes. But still no input signal at all...

Do I need another program in between to translate the AKAI's signals to DVC3?

I'm using the AKAI APC40 to control Traktor 2. Therefore I need MT-Player to transfer signals to Traktor....

Any idea?? Is it possible to send signal back to the AKAI mini to control LEDs??

Really need your help with that...
Thanks!

I don't have an AKAI myself but it may need to be set to a specific general MIDI mode. Check 'input->select midi ports' to be sure that the port is enabled.