Daslight Forum

Hi,

Apologies if this question has been answered before, I did a bit of searching and couldn't find anything recent.

I am trying to have a Lanta Lighting Orion V2 in 14 channel mode work within the Virtual 3D Simulator. The problem I have is that the Bar appears as one single bar rather than 4 different sections as I would like. I thought that the way to achieve this was by creating multiple beams for the fixture the way I have created the fixture using the scan Library editor (I have already searched for one made by Das Light and came back with nothing). The way that I have my fixture set up is the following:

Channel 1 Red 1 Light Beam 1
Channel 2 Green 1 Light Beam 1
Channel 3 Blue 1 Light Beam 1
Channel 4 Red 2 Light Beam 2
Channel 5 Green 2 Light Beam 2
Channel 6 Blue 2 Light Beam 2
Channel 7 Red 3 Light Beam 3
Channel 8 Green 3 Light Beam 3
Channel 9 Blue 3 Light Beam 3
Channel 10 Red 4 Light Beam 4
Channel 11 Green 4 Light Beam 4
Channel 12 Blue 4 Light Beam 4
Channel 13 Dimmer Light Beam All
Channel 14 Flash Light Beam All

Any help would be very much appreciated,
Regards

Thomas Edwards[/list]

Anything? Still haven't found a solution.

you hace to modify your fixture, you need to cut, in this way
fixture 1: 3channels (1-3)
fixture 2: 3channels (4-6)
fixture 3: 3channels (7-9)
fixture 4: 3channels (10-12)
(all this fixtures with the same sll profile)
you add them cheking the option matrix, then you put the secctions in the way you want

fixture 5: 2 channels (dimmer-flash 13-14)

you have une fixture, but in this way the software will recognize it as 5 fixtures, 4 repeated, and an aditional just for options. then you can use matrix effects from the effect generator.

I tried this with core 3x3 and it worked well.