Hello world.
I have the following: a dmx light table connected to Daslight kastje siudi 5a a computer Windows XP with dvc2 gold dvc2 software 25-07-2012 connected to Daslight Cabinet.
I have the following problem: I start daslight on.
In set-up patch an armature.
In editor I click with the right mouse button on ON under a fader slider.
Click dmx-input and a dmx light table scroll point so far.
I make a program and assign a dmx scroll there again.
So far everything works properly.
If I then shutdown and startup the program again, I can still call the program with my light table but which fader doesn't work any more.
I can only control the software again if I that fader completely remove from my computer and install again.
Who helps me with this problem off 'cause it works of course not.
Sincerely Jook
HELP! restart program DMX Input does not work anymore!
-
- Posts: 4
- Joined: Thu Aug 09, 2012 4:04 pm
- Location: Staphorst
- Contact:
HELP! restart program DMX Input does not work anymore!
Drive inn Banjo. helder in licht en geluid
-
- Posts: 60
- Joined: Sun Mar 25, 2012 1:52 pm
Same problem
Hello together,
I have got the same problem very often. Sometimes the software does nothing with the DMXin signal - it is ignored.
the-hubmaster
I have got the same problem very often. Sometimes the software does nothing with the DMXin signal - it is ignored.
the-hubmaster
-
- Posts: 4
- Joined: Thu Aug 09, 2012 4:04 pm
- Location: Staphorst
- Contact:
Yes I know.
I'm new to this forum and wasn't sure if I had posted correctly.
Hence my 2nd attempt.
I have my dvc2 sold to a room owner here but it must also become learning there. now I come into problems because the software that is now on the site State according to me not good Dashlight.
How quickly the problems here are normally resolved?
If anyone still has the old version of siudi5a and a dvc2, I am also ready I think.
Already fixed thanks for your effort.
Occasionally a bit flawed English maybe because I pressure my text by the translation engine but hope it to understand.
If I have sold my Jook greeting dvc2 dvc3 I switch on
I'm new to this forum and wasn't sure if I had posted correctly.
Hence my 2nd attempt.
I have my dvc2 sold to a room owner here but it must also become learning there. now I come into problems because the software that is now on the site State according to me not good Dashlight.
How quickly the problems here are normally resolved?
If anyone still has the old version of siudi5a and a dvc2, I am also ready I think.
Already fixed thanks for your effort.
Occasionally a bit flawed English maybe because I pressure my text by the translation engine but hope it to understand.
If I have sold my Jook greeting dvc2 dvc3 I switch on
Drive inn Banjo. helder in licht en geluid
-
- Posts: 4
- Joined: Thu Aug 09, 2012 4:04 pm
- Location: Staphorst
- Contact: