Programs in Live mode don't control moving heads

Alex_termito · Post by **Alex_termito** » Sat Jun 16, 2012 9:39 pm

I install DVC3. Then I create a new show with the same patch as I use in DVC2 and import in new show all programs from my old show which I use in DVC2. Those programs which control static fixtures and beam properties of the moving heads work perfect. Programs which contain only pan and tilt chanels do not affect on my heads. This problem only for the imported programs. Newly created programs works as it is.
P.S. Maybe this situation is normal. But for me it's a problem. I must create my big show from zero. It's about 60-70 programs.
Configuration: firmware ver. 1.18 on 30 march 2012, software - 04 may 2012, Windows XP sp3 x32 bit, DVC2 GZM.

Alex_termito · Post by **Alex_termito** » Sun Jun 17, 2012 8:01 pm

Problem was solved. That was my mistake.