Hey
I have just made a firmware update on my DVC2 128M because of the DMX signal sometime was unstable, But now after the update I can´t anything to work, both the red and the green LEDs are flashing like before, but notthing works
So what can I do ??
Best Regards
Johnny
Firmware upgrade
-
- Posts: 4
- Joined: Sun Feb 12, 2012 8:12 am
Make sure you are upgrading with the tools version included with your DVC2 installation. For example a firmware from a July release may not work with a december release.
Make sure tools is closed when you open DVC2 as only 1 application can access your interface at a time
I am assuming you are using the latest version from the website
Make sure tools is closed when you open DVC2 as only 1 application can access your interface at a time
I am assuming you are using the latest version from the website
-
- Posts: 4
- Joined: Sun Feb 12, 2012 8:12 am
I´am not useing the tools.exe do update my firmware but I used the program from
http://www.daslight.com/online_manuals/ ... dfPJk8.htm
MAybe that was wrong ?? but hov do i get it to work again ?
http://www.daslight.com/online_manuals/ ... dfPJk8.htm
MAybe that was wrong ?? but hov do i get it to work again ?
-
- Posts: 4
- Joined: Sun Feb 12, 2012 8:12 am
So now I have installed DVC2 from the CD and run the Tools.exe, the program tells me that there id no need for firmware upgrade, and when I run the test I can see the leds har flashing, but nothing happens. If I try to run Virtual Controller 2 the program run in demo mode, it can´t find the DMX controller
Install the latest DVC2 14th Feb version from the website
Open the Hardware Configuration-tools application included with this version
Update the firmware
Test by moving the fader on the test tab
Close the Hardware Configuration and open DVC2 14th Feb
Is your interface detected by the hardware configuration application?
Do you have a DMX output from the hardware configuration application?
Is your interface detected by DVC2 14th Feb?
Open the Hardware Configuration-tools application included with this version
Update the firmware
Test by moving the fader on the test tab
Close the Hardware Configuration and open DVC2 14th Feb
Is your interface detected by the hardware configuration application?
Do you have a DMX output from the hardware configuration application?
Is your interface detected by DVC2 14th Feb?