DA4 Stand Alone Standalone Mode

[bf5502]

I just setup scenes to the Gold interface and for the most part they work fine. I noticed that I can trigger a scene to start, but I can't make it stop unless I create a scene for that fixture that turns it off. Is that the correct way to deal with that? I want the scene to continue till I turn it off. On the PC software I can click on and click off, but not on the interface.

I have some fixtures that have scenes that will turn on and change to other scenes, but when I create a "off" scene, it doesn't even transfer to the interface. It works on the PC software as expected. These fixtures are more complex than the ones mentioned previously. Any guidance would be appreciated.

[Frossuche]

Check memory usage. In the PC software, use the standalone export tool to see how much memory each scene uses.geometry dash spam