UDP Trigger Guide

[tuxayeti]

Hello,

I found following information in the DVC Gold Datasheet:

UDP Network Triggering
The controller can be connected to an existing automation system
using a local area network (LAN) and triggered via UDP packets
on port 2430. Refer to the remote protocol document for more
information. Note: This interface cannot be controlled over the
internet.

Can Anyone give me the remote protocol document to programm an interface with our SPS? Or maybe have an other Guide?

THX Stefan

[JamesMGrate]

Hi everyone, I think it takes a lot of time to find the following information in the DVC Gold Data Sheet and as you said above you need to enable the network and refer to the documents via remote protocol. You can also refer to the platforms for more information on this issue.