Hi.
I have created multiple scenes and will be operating them using the 'go to next button' so they all follow our show, however, I needed to insert a new scene in the middle of the set. When I arrive at the new scene that I have created the scene plays and then when I click the 'go to next button' the scene jumps back to the start of the show (first scene). I have checked all the scene parameters and characteristics to make sure the settings are all correct (jump to, release etc) and the scene name does not clash with any other, but the results are the same. If I skip past the new scene and play the next scene and then click the 'go to next button' the scene plays but then doubles up with the next scene and this repeats to the end of the show (2 scenes playing together!). However If I delete the new scene everything plays normally again. Any clues???
Regards
Dave H
Scene wont go FWD
See my reply in your other post about this http://www.daslight.com/support/viewtop ... =2020#2020
Andre
Scene wont go FWD
Hi Andre
I Have emailed you part of my show for you to check out
Regards
Dave H
I Have emailed you part of my show for you to check out
Regards
Dave H
Dave H
I have spoken to Dave H about this via email but here is a quick synopsis of the result.
I got the show and could not find anything wrong with it, all worked as it should.
Told Dave and suggested that he might need to go through a un-install, clean up and re-install as possibly something has got corrupted.
Dave did a reboot of his computer and all is well with the existing show and nothing else had to be done.
Which to me indicates that it must be a memory leak or some other problems with the program for it not to run correctly until a reboot has occured. I must admit if I have done a lot of editing I do get some corruption of the loaded show, nothing serious but damn frustrating. Must remember to close program and re-boot machine more often when doing lots of editing etc.
I got the show and could not find anything wrong with it, all worked as it should.
Told Dave and suggested that he might need to go through a un-install, clean up and re-install as possibly something has got corrupted.
Dave did a reboot of his computer and all is well with the existing show and nothing else had to be done.
Which to me indicates that it must be a memory leak or some other problems with the program for it not to run correctly until a reboot has occured. I must admit if I have done a lot of editing I do get some corruption of the loaded show, nothing serious but damn frustrating. Must remember to close program and re-boot machine more often when doing lots of editing etc.
Andre