Invert Zoom-Channel

Software tool to create and modify all your fixture libraries

Moderators: Ksel, TomHat, simonB

mheidler@heimedia.de
Posts: 8
Joined: Fri Apr 20, 2012 7:42 pm
Location: Germany/Darmstadt
Contact:

Invert Zoom-Channel

Postby mheidler@heimedia.de » Thu Oct 28, 2021 6:42 pm

Is there any posibility to invert the zoom-channel of a fixture?
My Movighead has a large spot by DMX-Level of 0 and zooms to small if I increase the level up to 255.
Thats a problem, because I use the 3D-Visualizer to program my shows offline.

Thank you,
Michael

TomHat
Posts: 1166
Joined: Tue Feb 23, 2016 9:11 am
Location: France
Contact:

Re: Invert Zoom-Channel

Postby TomHat » Thu Nov 04, 2021 8:18 am

Hello,

Sadly it is only possible to invert Pan/Tilt DMX channels. Although if the values are shown backwards, maybe the fixture profile was not created properly and one needs to edit it using the ScanLibrary Editor tool (installed with Daslight4)

Hope this helps.

Regards,
TomHat
--
Daslight Support

Mail : france@daslight.com
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500

mheidler@heimedia.de
Posts: 8
Joined: Fri Apr 20, 2012 7:42 pm
Location: Germany/Darmstadt
Contact:

Re: Invert Zoom-Channel

Postby mheidler@heimedia.de » Sat Dec 04, 2021 10:49 am

Hello TomHat,

thank you for your answer.
I can't find any posibilyty to fix that problem in the ScanLibrary Editor. It ist not posible to invert it here. DMX 0 is everytime a small beam and 255 a large one.

Scanlibrary Editor and 3D Simulation works fine, the best way woud be, that the Manufactor of the MovinHead woud fix that problem in the Firmware of the MH. Normaly a DMX Level of 0 should show a small beam, andd 255 a large one and not vice verse.

Regards,
Michael


Return to “Scanlibrary”

Who is online

Users browsing this forum: No registered users and 1 guest

cron