Does anyone know how the DMX Input patching works ?
I can do a straighht patch that works OK, but if I want to patch an input from my desk that is using address 241 for example and I want it output to address 123 then putting the parameters in does not seem to work. I have 241 in the Input part and Universe 1. In the outputs I have Universe 1 and address 123. Click apply. Try it and nothing. Right click the channel again and select Input and it has reverted back to it's defaults.
Also what does all the stuff at the bottom of the Output Mode Setting mean ?
ex: 5+6+7+8+9 = 5.9 = 5+6+7.9
DMX Input patching
DMX Input Patching
Hi Andre
I have just tried input patching on DVC2 and it worked fine for me, I patched input ch12 universe 1 to output ch24 universe 1. Also the stuff at the bottom of output patch is for grouping channels ie 1-50 selects ch1 through ch50 then select which mode you want those channels on, DMX Input. Midi, Auto, etc. Hope this has been of some help to you.
I have just tried input patching on DVC2 and it worked fine for me, I patched input ch12 universe 1 to output ch24 universe 1. Also the stuff at the bottom of output patch is for grouping channels ie 1-50 selects ch1 through ch50 then select which mode you want those channels on, DMX Input. Midi, Auto, etc. Hope this has been of some help to you.
DMX Input Patching
Hi Andre
Yes I have 192chs used on generic lamps and ch200 to ch224 for Stairville 250mh movers then ch230 to ch 255 for RGB Cans. Some shows we also use 12 Mac 250mh movers. Sometimes I use ETC Express250 as external desk but it is useless for movers, although can be handy as external desk. I again tried an input patch this morning and discovered it is easier to patch in Setup on DVC2.
Yes I have 192chs used on generic lamps and ch200 to ch224 for Stairville 250mh movers then ch230 to ch 255 for RGB Cans. Some shows we also use 12 Mac 250mh movers. Sometimes I use ETC Express250 as external desk but it is useless for movers, although can be handy as external desk. I again tried an input patch this morning and discovered it is easier to patch in Setup on DVC2.