Ports doesn't work *solved*

ljudkillen · Post by **ljudkillen** » Fri Mar 09, 2012 10:36 am

I have set up some scenes to trig from port and address. It doesn't respond to port commands. Everything else works as expected.
When I look in Tools/Test the Port state for port 3 and 4 is marked. I can see the closures works on the other ports.

Is it broken? It seems like port 3 and 4 are shorted, maybe a bad soldering. i don't want to resolder it since I maybe have to use the warranty.

I have updated the firmware (again) to 1.11
Any idea anyone?

ljudkillen · Post by **ljudkillen** » Mon Mar 26, 2012 3:55 pm

I bought another one. Delivered today. Same fault!

Did you have a bad soldering day?

Serial:364437, 353729

Post by **simonB** » Fri Mar 30, 2012 12:05 pm

This was a problem with a batch of interfaces. I guess you purchased 2 from the same batch. See here for more information:
http://www.nicolaudie.com/online_manual ... gY7Js2.htm

ljudkillen · Post by **ljudkillen** » Mon Apr 02, 2012 6:29 pm

The two 10k resistors made it work.

Daslight Forum

Ports doesn't work solved

Ports doesn't work solved