I'm running Daslight lastest version and DVCFUN Latest firmware on Windows 10 latest patches.
I have a problem generating a tilt effect for my light fixture 'Ibiza-Light 9 beam mini'.
The fixture has 3 tilt-units (each unit containing 3 lights) which can tilt.
I can setup a Curve-Sine effect and select tilt1, tilt2 and tilt3.
See attached file
Then I can see all 3 heads moving up and down. So that's good.
See attached file
But when I generate the effect (with or without the 'include set levels') option,
only the tilt3 ends up moving in the generated result.
See attached file
I then tried to generate 3 different tilt Curve-Sine fx, one for each tilt.
I can see all 3 heads moving up and down again,
but after generating, only the tilt3 ends up moving.
Could someone tell me what I'm doing wrong, because this has cost me 4 hours already and I'm out of options
Problem after generating an effect with 3 tilts
-
- Posts: 5
- Joined: Wed Sep 08, 2021 11:41 am
- Operating System: Windows
- Location: NL
Problem after generating an effect with 3 tilts
- Attachments
-
- FX Configuration
- 9beam_fx_config.png (84.97 KiB) Viewed 2035 times
-
- during FX all works
- 9beam_Before_Generation.png (92.05 KiB) Viewed 2037 times
-
- after generation only 3rd tilt works
- 9beam_after_generation.png (210.47 KiB) Viewed 2037 times
-
- Posts: 5
- Joined: Wed Sep 08, 2021 11:41 am
- Operating System: Windows
- Location: NL
Re: Problem after generating an effect with 3 tilts
I ended up testing again last night and found the solution to my problem.
The light fixture SSL2 was configured as a moving head TILT on the 3 tilt-channels. This makes sense
But when I reconfigured the 3 tilt-channels as UNKNOWN (?) and set the values as UNDEFINED 0-255 linear, the generation of all 3 channels worked fine and they were moving at the same time! See attached file.
So, I don't know how to reach development, but this looks like a software-bug to me.
The light fixture SSL2 was configured as a moving head TILT on the 3 tilt-channels. This makes sense
But when I reconfigured the 3 tilt-channels as UNKNOWN (?) and set the values as UNDEFINED 0-255 linear, the generation of all 3 channels worked fine and they were moving at the same time! See attached file.
So, I don't know how to reach development, but this looks like a software-bug to me.
- Attachments
-
- 9beam_fixed.png (41.39 KiB) Viewed 2010 times