problem with midi and some fixture
-
- Posts: 25
- Joined: Sat Mar 17, 2012 6:32 am
problem with midi and some fixture
Setting some dmx channel in some fixture control i have problems. If i set the midi, and give the "ok" .... no controls are set and a little red point in the top of the control turn on.
- Attachments
-
- midi fixture error.jpg (55.41 KiB) Viewed 4569 times
Re: problem with midi and some fixture
Hello,
Could you try selecting fixtures before you mode the MIDI slider ?
Regards,
Could you try selecting fixtures before you mode the MIDI slider ?
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
-
- Posts: 8
- Joined: Fri May 29, 2020 6:02 pm
- Operating System: Windows
- Location: Chesterfield,GB
Re: problem with midi and some fixture
I am also seeing the same problem on some fixtures, with the same red dot at the top
Some options let me map faders & other controls fine however certain controls will allow me to map a function and detects the midi during the mapping process, yet after clicking OK the midi input does nothing, checking the inputs daslight is getting from the midi controller it is getting the correct information yet nothing happens.
I'll record a short video of the problem shortly
Some options let me map faders & other controls fine however certain controls will allow me to map a function and detects the midi during the mapping process, yet after clicking OK the midi input does nothing, checking the inputs daslight is getting from the midi controller it is getting the correct information yet nothing happens.
I'll record a short video of the problem shortly
Paul
Lighting Design for Wrestling Events & Band's
Lighting Design for Wrestling Events & Band's
-
- Posts: 8
- Joined: Fri May 29, 2020 6:02 pm
- Operating System: Windows
- Location: Chesterfield,GB
Re: problem with midi and some fixture
Whilst recording a video for this I have found a solution that seems to work, instead of choosing fixture type at the bottom, select general to show all faders, make sure you select the correct universe(this issue only seems to happen when I run more than 1 universe) then right click the fader and set your midi values
Paul
Lighting Design for Wrestling Events & Band's
Lighting Design for Wrestling Events & Band's