When I start up Daslight 4 or reconnect the USB interface, I need to reselect the universes. Both universes are blank and I need to reconfigure the universes. Also this happened last time during session that both universes where blank and I lost control over the whole show. After checking the universes, I was able to continue.
Also I use the DVC4 Gold and use the two connectors as outputs with the same universe. But everytime I need to reconfigure the universes.
When starting up or reconnecting usb need to reselect universes
Re: When starting up or reconnecting usb need to reselect universes
Hello,
I just sent you a link to a private version. Could you please let me know if the problem is fixed for you in this one ?
Best regards,
I just sent you a link to a private version. Could you please let me know if the problem is fixed for you in this one ?
Best regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500