Daslight Forum

hey guys,

does this artnode automatic detected by daslight to configure outputs?
i do buy the dvc 4 GZM

i dont see the way to do it in the manual to forward the artnet universus to the correct dmx port:

https://www.highlite.com/media/attachments/MANUAL/50804_MANUAL_GB_V1.pdf

Hello,

Some artnet nodes aren't automatically detected by Daslight4. You might then need to configure your own Node in the software, using the preference window's "Devices" section :

Click "Add Virtual Device", pick the IP address to your ArtNet node and click "OK". Then you'll just need to add and configure as many DMX universes as your ArtNet node can handle.



Hope this helps.

Regards,

Oké, and then my output 1 is automatic universe 1, output 2 universe 2 etc ?

It should work like that yes, but you can always decide which Daslight4 universes to set on your node's outputs.

Hope this helps.

Regards,

Hello

just to be clear, we need to connect the node to the ethernet port of the computer ? right ?

Hello,

It should be enough with the computer and the ArtNet node being connected on the same network.

Regards,