Daslight Forum

I have a question.

I use Daslight Virtual Controller 3 with a Sushi USB Interface to DMX.


If I start the steps in the scene individually, the scanner moves correctly. As soon as I start the steps with Play, the steps are not carried out correctly.
Even creating different scenes at different speeds does not change anything in the process. Does somebody has any idea?

i testet ist new.

the problem is when i change the fade time the scanner have the same speed.

I tested again and set 2 points as steps if I now set the following fade time here the result 01m00s56 is good scanner runs very slowly
00m00s56 is good scanner runs very quickly 00m04s56 scanner only runs in part of the points, not the entire area which is specified

woehners wrote:I tested again and set 2 points as steps if I now set the following fade time here the result 01m00s56 is good scanner runs very slowlyWorld's Hardest Game
00m00s56 is good scanner runs very quickly 00m04s56 scanner only runs in part of the points, not the entire area which is specified

We may have to test more. It will give us different results. Maybe.