Daslight Forum

that's exactly what i wanted to tell you

Hey,

be sure that all your scenes you need simultaneously have the right release mode (off / group / ...)

for my part, the error does not occur any more....

sure, you changed a lot... but they did you remove the feature of giving buttons a picture???

Got the same problem with the DVS.

Also some others here: EasyRemote App

edit/push

Hello again, I'm working with the EasyRemote App for a while now. There are two points that I am bothered by: ⋅  edit: some real bad experience today: in DVS I had 1 page. I put in a background image as centered (exact the size). Then I added another page. When I switch back to page 1, the...

Did you create an own fixture or did you use one out of the library? If it's an own one, check your settings of the color wheel. How did you inserted the RGB/CMY then? Standard mode is the "classic" mode. If you change for example the pan position it drives there. It has just 18 channels. ...

yes... it's because LTP is standard in nowadays light control software

I think the advantage over one of them depends of your programming. Here is - in my view an easy - example: LED-PAR - 4 channel (R,G,B,dim) scene1: full blue on (0,0,255,255) scene2: full red on (255,0,0,255) LTP: start 1: blue start 2: red HTP: start 1: blue start 2: magenta!! (because all the high...

I hope, you get the difference: imagine you have 2 scenes: ⋅ 1st gives you a dmx value of 200 in channel 1 ⋅ 2nd gives you a dmx value of 100 in channel 1 Now: HTP = highest takes precedence or "who shouts loudest , is right" ⋅ start scene1: DMX -> 200 ⋅&...

You need to set the "Release" in all scenes to "OFF" for example.

that's correct (as far as i know)

the bar fixture is shown as a stripe
the conventional is shown with 1 spot

but remember, the visualizer does not show the real output, so normally it's not that important what the 3d shows

The 3d simulator can only show 1 lightbeen, even if more lightbeams were put in. So if you select r/g/b and a/w it only shows r/g/b selection. But the dmx-output should be correct.

The colored bar is shown, because you have selected "LED Bar" in fixtures options.

Sounds good! It would be nice, that one fixture would have an other fader-color like the fixture next in DMX, like it is, if you have two or more same fixtures patched at once. The backgrounds of the general tab channels change between dark and light. Is this not enough? It just changes, if I patch ...

edit: maybe a silly question regarding the DVS, but: I've got 2 buttons. On each button I want to start 1 scene and stop the scene played of the other button. I tried that with the commands "STOP #1" "PLAY #0" and reverse, but it doesn't work. The old scene does not stop! Is ther...