DVC3 crashes when trying to open DVC2 Show

MLC Disco · Post by **MLC Disco** » Mon Dec 12, 2011 10:38 am

Hi

I have tried to open a DVC2 show with version 3 but it crashes annd shows the "Windows has stopped working " screen.

I am using Windows 7 Ultimate (32bit Version).

Also by installing Version 3 with this effect Version 2 already installed. I have noticed when I use version 2 now the interface is now showing at DVC3. I haven't used any of my lights yet so I am hoping all the DMX values are being sent!

regards

Sean

Post by **simonB** » Mon Dec 12, 2011 4:58 pm

Hi
We are aware of the DVC2 show problems (see thread below this one). We'll look into it throughout this week. The DVC3 installation should not affect DVC2 in any way.