Daslight Forum

Hey Folks,

I am curious about, to figure out, how I could send Daslight 5 Scenes (DMX Data) via ArtNet to another Software.

My hardware is a DVC Fun with a full license.
Some talked about a "ArtNet universe module" but where I can get this?
Do I really need this, for open a virtual device for sending DMX data from Daslight 5 to another software???

Other thing is, if I open QLC+ and open a local host ArtNet as Input, than open Daslight 5 I get a virtual device visible.

But it seems, that this do not work correctly.

The only thing is what I want, such most virtual DMX Controller can:

Sending DMX data from one software to another, for visualize for exampe in Unreal Engine (with a virtual ArtNet device)

If I use the same configuration in QLC+ I can send without issues to Unreal Engine.
But Daslight 5 has issues to send data out virtual to Unreal Engine.

Thank you in advance

so you have this set up properly, but you need a dvc device with proper license and an artnet channel bought before the software will allow you to output artnet

DJMan32 wrote: ↑Thu Apr 25, 2024 2:07 pm so you have this set up properly, but you need a dvc device with proper license and an artnet channel bought before the software will allow you to output artnet

Hi DjMan32,

thank you for the reply. Yes. I have a Daslight device but only the DVC Fun. In the webstore I cannot find any option, to buy an ArtNet module.
I would appreciate it a lot, if you could help me to get the ArtNet channel.
My license for the DVC Fun is a full license.

Is the update what I would need that one in the picture with the arrow and this works with the DVC Fun also?

yes, you need to purchase one of those

not actually another piece of hardware,

DJMan32 wrote: ↑Fri Apr 26, 2024 5:42 pm not actually another piece of hardware,

Great! Thank you for your kind help

I was not sure, if this is really for that ArtNet solution. Looking a bit confusing.