DVC GOLD UDP Triggering

[reba691]

Hi!
In the DVC Gold datasheet (https://eu-litterature.n-g.co/Release/d ... eet_en.pdf) it says that
"The controller can be connected to an existing automation system using a local area network (LAN) and triggered via UDP packets on port 2430."

For more info about that it further says: "Refer to the remote protocol document for more information."

Where can I find this document? Please post a link here @simonB @TomHat. Thanks!

Best regards

[Solli479]

Hello,

I need these information, too.

So please be so good and send the link

Thank you in advance.

Best regards.

[TomHat]

Hello,

Sorry for the late reply.
Here is the document you need : https://eu-litterature.n-g.co/Release/s ... ontrol.pdf.

Hope this helps.

Best regards,

[Solli479]

Hello TomHat,

thanks, helps a lot.

When the DVC Gold is in stand alone after power up, receive it the UDP commands sendet e.g. from a Streamdeck or receive DVC only in live mode UDP commands?

Thanks again.

Best regards.

[TomHat]

Hello,

The UDP commands are only handled by the DVC Gold in Stand Alone mode.

Regards,