BUG: ColorFX dont want to map on all LIghts proparly.
If i drop Colormap on all LIghts one of these LEDBars is not working proparly. See Screenshot below.
One Pixel ist not Active. If i select from Top to Down then the lower on is not active. When i select from Down to Top, one of the upper lights have a pixel out. so its not a dimmer problem.
BUG: ColorFX dont want to map on all LIghts proparly
Re: BUG: ColorFX dont want to map on all LIghts proparly
i found the problem. If you put on Transform: Vertical symmetry thenone Pixel Light of a Bar turns off. Thats a BUG i think. When i use without vertical symmetry then i works fine. Still should be fixed, or what do you think ?
as far as i have found Rainbow mode and Burst Mode is wrong.
This is without Vertical symmetry:
as far as i have found Rainbow mode and Burst Mode is wrong.
This is without Vertical symmetry:
Re: BUG: ColorFX dont want to map on all LIghts proparly
Hello
It's probably because there is an odd number of beam
Regards
It's probably because there is an odd number of beam
Regards
Re: BUG: ColorFX dont want to map on all LIghts proparly
ah ok thats the matter, thank you