Startup DVC2 takes a long time

DJ-Rene · Post by **DJ-Rene** » Thu Jun 23, 2011 1:26 pm

When i start Daslight VC 2 (Version 05/05/2011) it takes about 3 Minutes to load my show. When i startet Daslight with the devault show it starts immediately.

Why does the startup with a programmed show take so long?

Post by **simonB** » Fri Jun 24, 2011 6:50 am

e-mail me your show and I'll test

DJ-Rene · Post by **DJ-Rene** » Sat Jun 25, 2011 1:16 pm

I#ve send you my show, thanks for your support!

DJ-Rene · Post by **DJ-Rene** » Mon Jun 27, 2011 7:34 am

simonB wrote:e-mail me your show and I'll test

Hi Simon, did you have any Infos for me about the problem with my show?

Post by **simonB** » Tue Jun 28, 2011 9:38 am

I timed your show and it took 23 seconds to load. I have sent your show over to the developers to see if this is normal or not

DJ-Rene · Post by **DJ-Rene** » Sat Jul 09, 2011 8:42 am

simonB wrote:I timed your show and it took 23 seconds to load. I have sent your show over to the developers to see if this is normal or not

Any Updates?

Post by **simonB** » Mon Jul 11, 2011 1:52 pm

Hi, we took a look at your show.

It is normal to have a wait as you have used a lot of scenes and some scenes contain over 800 steps. There are a total of 11139 steps in your show.

3 minutes seems a long time though, maybe you should upgrade your computer. I loaded your show in 23 seconds and I tested on a standard middle range 2 year old dell computer which took 18 seconds.

DJ-Rene · Post by **DJ-Rene** » Wed Jul 20, 2011 5:05 am

Thanks Simon, I'm using Daslight on a Netbook. It's not powerful PC, but it's only for lightcontrol and when Daslight up it works very fine.