DVC4 Gold stand alone pan/tilt problem

[djtheglove]

I recently bought the new DVC4 Gold Interface and was happy to be able to quick select scenes with the buttons. Now I have the Problem, that I programmed a scene with Movingheads for example 6 steps of moving with fade time. Inside the software everything works fine and the heads move as programmed. But when I put that scene onto the interface in stand alone mode, the moving heads do not move like programmed. It seems like they always go to pan/tilt point zero between each step and than to the programmed point. Any chance to solve that problem?

[TomHat]

Hello,

Can you send over your showfile for some tests ?

Regards,

[djtheglove]

Hello,

Can you send over your showfile for some tests ?

Regards,

Showfile is on its way.
Btw. with the old DVC3 Interface there is no problem, using the same scenes.

Thanks and regards

Lars Baecker

[georgelake]

Let's check the settings and configurations for standalone mode on the DVC4 Gold Interface. Make sure that the settings are configured correctly to accurately replicate the programmed scene behavior. geometry dash lite