DVC4 Gold standalone in a museum triggering with two sensors

512 In, 512 out or 2x512 out. Stand Alone memory (512 out)

Moderators: TomHat, P-Low, simonB, Ksel

tbingel
Posts: 1
Joined: Tue Dec 03, 2019 3:05 pm
Operating System: Windows

DVC4 Gold standalone in a museum triggering with two sensors

Postby tbingel » Wed Dec 04, 2019 7:12 am

Hi,
I am considering using DVC4 Golds in a museum project of ours.
This is the scenario I have in mind;
In the morning a static scene loads triggered by RTC,
a presence sensor monitors a hall with several exhibits and triggers a dynamic scene when visitors are present via a dry contact port,
another sensor monitors the close vicinity of a particular exhibit and triggers another dynamic scene which focuses on this exhibit,
a master blackout scene is triggered when the visiting hours are over each day.
There will be only three fixtures and a mini laser with a total of 179 channels for each dvc4 Gold.
Would this work?
Thank you.

P-Low
Posts: 47
Joined: Wed Feb 27, 2019 9:53 am
Location: Brighton
Contact:

Re: DVC4 Gold standalone in a museum triggering with two sensors

Postby P-Low » Tue Dec 10, 2019 9:07 am

Hello

In theory what you wish to achieve is possible, however if you are using the device in Stand Alone mode, you may need to use the DVC4 GZM interface so that you can have more than one scene playing at once via the use of 'pages' on the device. If you were to use the DVC4 Gold in Stand Alone mode, you would be limited to playing only one scene at a time.

If you were to use live mode, you should be able to control and operate as you desire with the DVC4 Gold, but this would require you to have a computer running continuously whilst being used.

Kind Regards
Daslight Technical Support


Return to “DVC4 GOLD / DVC3 GOLD / DVC2 GOLD”

Who is online

Users browsing this forum: No registered users and 0 guests