Hey my name is Daniel from Germany,
i'm actually use the Daslight4 in the show mode with a few led and old par spots (relay switch)
If i turn all spots off and shutdown the pc, all lights will switch back on.
Then i turn the pc back on and start Daslight..all lights off now.
i also erase the standalone scene on my interface.
The problem isn't always but sometimes
Sorry for my english mistakes.
Greetings
Daniel
Daslight 4 shutdown problem
-
- Posts: 2
- Joined: Sun Nov 11, 2018 11:22 am
- Operating System: Windows
Re: Daslight 4 shutdown problem
Hello,
Please answer these 2 questions :
- I assume the interface is plugged to your PC, right ?
- Does this problem also appear when you only turn off Daslight4 ? Or is it only when you turn off the computer ?
It seems like "lights ON" is the default state of your lights, which they go back to when they stop receiving DMX signal.
Hope this helps.
Regards,
Please answer these 2 questions :
- I assume the interface is plugged to your PC, right ?
- Does this problem also appear when you only turn off Daslight4 ? Or is it only when you turn off the computer ?
It seems like "lights ON" is the default state of your lights, which they go back to when they stop receiving DMX signal.
Hope this helps.
Regards,
TomHat
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
--
Daslight Support
Mail : [email protected]
Phone (French) : +33 (0) 616 427 588
Phone (English) : +44 (0) 7 481 811 500
-
- Posts: 2
- Joined: Sun Nov 11, 2018 11:22 am
- Operating System: Windows
Re: Daslight 4 shutdown problem
Thanks for the Answer!
The Interface is connected with some DMX Switchpacks. Each Switchpack have 4 Channels of 230v.
If i shutdown my Computer, a few lights (Switchpack Channels) will turn on again
Only Sometimes and always another one.
If i turn on the Computer then, all lights go off until i restart Daslight and Switch the lights back on.
So, i think the Standalone Funktion send a wrong Signal to the dmx output when the computer is down.
I hope you understand my worst english:D
Thanks alot
Daniel
The Interface is connected with some DMX Switchpacks. Each Switchpack have 4 Channels of 230v.
If i shutdown my Computer, a few lights (Switchpack Channels) will turn on again
Only Sometimes and always another one.
If i turn on the Computer then, all lights go off until i restart Daslight and Switch the lights back on.
So, i think the Standalone Funktion send a wrong Signal to the dmx output when the computer is down.
I hope you understand my worst english:D
Thanks alot
Daniel