Showtec Phantom 250 Spot ---SSL

daf_vision · Post by **daf_vision** » Fri May 15, 2009 7:25 pm

Hello. I intend moving two of the heads to buy. I wanted to but sometimes in the software and how they manage and what opportunities there are for. However, I have no file in the device library for a Showtec Phantom 250 Spot found. Did someone perhaps such a file for 16-bit control. Thank you very much

Andre · Post by **Andre** » Sat May 16, 2009 1:31 pm

Use the Scanlibrary program to create the fixture you need.

daf_vision · Post by **daf_vision** » Sat May 16, 2009 1:59 pm

Hello Andre. The problem is that the device I have not yet. I currently see some devices with each other and looking for a fitting, which I then buy. It must be so good with the tax software tolerated. I have neither a channel nor a manual of this device. Yes I would write a file when I channel allocation plan would have. Did someone perhaps such a device (Showtec Phantom 250 Spot) and controls it with DVC2? Requesting device library file. Thank you and best regards from Cologne

Andre · Post by **Andre** » Sat May 16, 2009 3:54 pm

It took me 30 seconds to find the manual.

I have posted a link below. That site has all ?? of Showtecs manuals past and present.

Hope that helps in building you fixture file.

http://www.showfotos.nl/manuals/SHOWTEC ... Spot-E.pdf

daf_vision · Post by **daf_vision** » Sat May 16, 2009 5:22 pm

Thank you for your help. I will try to create the device.

daf_vision · Post by **daf_vision** » Tue May 26, 2009 9:25 am

Hello. I tried to file for the SSL Phantom 250 Spot to create. The program editor Scanlibrary reports me an error in the file. Could you please look why. Thank you very much

http://rapidshare.com/files/237351728/P ... t.ssl.html

Andre · Post by **Andre** » Tue May 26, 2009 5:18 pm

daf_vision wrote:Hello. I tried to file for the SSL Phantom 250 Spot to create. The program editor Scanlibrary reports me an error in the file. Could you please look why. Thank you very much

http://rapidshare.com/files/237351728/P ... t.ssl.html

It's fine except for in your Funktion channel 11 you have 3 values named "no funktion". Values 4, 59, 119. All you need to do is rename the "no funktion" for values 59 & 119 to "No funktion 1" and "no funktion 2".
That is what the message "Problems appeared. - There are two presets with the same name" means, you cannot have 2 presets in the same channel with the same name, even if the do the same thing.

Other than that well done.