Too less light beams compared to channels
Posted: Sun Jun 22, 2014 4:40 pm
Hi Support,
I tried to create a fixture for the new eurolite KLS-2500, a light bar with 4 led lights, each LED with 5 colours (RGBAW).
In the setup I defined 4 light beams. Then I added the channels. Beside functions and dimmer, for each light beam 1 x RGB 2 x colour mixing (for amber and white). I defined all (RGBAW) for light beam 1 and then repeated it four times for all lights.
Then I tried to save the ssl2 and got the error message:
---------------------------
Cannot save the profile
---------------------------
The light beams count (4) doesn't match with the channels (8)
---------------------------
I just can save it, when I set all colour mixing channels to light beam "all", which is wrong.
I think, that Scanlibrary can't handle LEDs with more than 3 colour correct.
See also the fixture for the eurolite "LED KLS-2001" which is part of the delivered library. There the colour mixing channels (amber and white) are set to "all" beams too although the channels influence always just 1 beam.
When this will be fixed?
KR
Pierre
I tried to create a fixture for the new eurolite KLS-2500, a light bar with 4 led lights, each LED with 5 colours (RGBAW).
In the setup I defined 4 light beams. Then I added the channels. Beside functions and dimmer, for each light beam 1 x RGB 2 x colour mixing (for amber and white). I defined all (RGBAW) for light beam 1 and then repeated it four times for all lights.
Then I tried to save the ssl2 and got the error message:
---------------------------
Cannot save the profile
---------------------------
The light beams count (4) doesn't match with the channels (8)
---------------------------
I just can save it, when I set all colour mixing channels to light beam "all", which is wrong.
I think, that Scanlibrary can't handle LEDs with more than 3 colour correct.
See also the fixture for the eurolite "LED KLS-2001" which is part of the delivered library. There the colour mixing channels (amber and white) are set to "all" beams too although the channels influence always just 1 beam.
When this will be fixed?
KR
Pierre