No response to ports in stand alone mode
Posted: Thu Dec 06, 2012 4:31 pm
Hi, While the unit plays back perfectly in live from the software with the scenes I've made and they overlap perfectly when I trigger multiple scenes, when I write the scene and then trigger them from the ports, nothing happens?
The ports are showing as being triggered in the hardware configuration tool, but do nothing when I go into actual stand alone mode, the display just sits on A01.
The port config worked fine on the standard DVC3 i was trying before so I'm pretty sure I've allocated the ports correctly so it should be doing something.
Serial number is 106474 and firmware is 1.9.
Help please!!!!
Cheers
Simon
The ports are showing as being triggered in the hardware configuration tool, but do nothing when I go into actual stand alone mode, the display just sits on A01.
The port config worked fine on the standard DVC3 i was trying before so I'm pretty sure I've allocated the ports correctly so it should be doing something.
Serial number is 106474 and firmware is 1.9.
Help please!!!!
Cheers
Simon