Hi Everyone
I Have Been Having Problems With My Daslight Controller because i make my scene's in demo mode then i plug my dv2 gold controller and then 1 of my ACME WINNERS in and the scene will work.
BUT
When I come to plug all 4 Of my ACME WINNERS in they will not work, they go to blackout mode but don't do the scene's
PLEASE HELP ME!!
I AlSO HAVE THE SAME PROBLEM WITH MY ACME IM5 WASHES
Thanks
Sam
SamClarkEntertainments
Problem With Control
Thanks
On My IM5 Washes they are digital like
they have no dimswitches or watever they are called
what do i do then?
they have no dimswitches or watever they are called
what do i do then?
Re: Thanks
sce wrote:On My IM5 Washes they are digital like
they have no dimswitches or watever they are called
what do i do then?
You still have to set the address of each of the fixtures to match what you have set them to in DVC2 setup.
Check the manual for how to set the address.
Andre
Continued
1. Go to where you have patched the lights, then for example, the washes have 6 channels - so i have choosen number 1 then on the next one 7
eg
hope this helps and thanks to everyone for the help
don't forget to change the amount of channels on the im5 washes to 6 they have defaulted it to 5
eg
hope this helps and thanks to everyone for the help
don't forget to change the amount of channels on the im5 washes to 6 they have defaulted it to 5
Re: Continued
sce wrote:1. Go to where you have patched the lights, then for example, the washes have 6 channels - so i have choosen number 1 then on the next one 7
eg
hope this helps and thanks to everyone for the help
don't forget to change the amount of channels on the im5 washes to 6 they have defaulted it to 5
You say the washes have six channels, from the manual I have found they have 7 channels. ( it is the same model just badged ).
http://prolight.co.uk/images/media/11/1 ... 01-um0.pdf
The channels are as follows
1 - Pan
2 - Tilt
3 - Shutter/Shaking
4 - No Function (Gobo on Spot version)
5 - Colour
6 - No Function
7 - Dimmer
So what you should be using is the im-5w fixture from the iSolution/IM folder when you are patching the fixtures.
When patching mutiple fixtures you just need to change the "count" to the number of fixtures you have it will put them in the right place in the patch and you can easily see the start address for each of these fixtures.
There is no need to patch each one individually.
Remember to set the address accordingly on the fixtures as well.
Andre